Front top horizontal
Front bottom horizontal
Front left vertical
Front right vertical
Left top horizontal
Left bottom horizontal
Right top horizontal
Right bottom horizontal
Back top horizontal
Back bottom horizontal
Back left vertical
Back right vertical
Arduino code generator
Cube transducer array. 24 transducers being 12 pairs. Each pair is along an edge.
For hardware setup of transducer array see Physicalize page.
- Choose the pairs to switch on with the options above.
- Generate the Arduino code.
- Copy it and upload it to an Arduino Mega.
Selected pairs (0 of 12): None. All pairs will be off.
Upload the sketch to an Arduino Mega (Mega 2560) from the Arduino IDE: select Tools > Board > Arduino Mega or Mega 2560, choose the port, then click Upload. Pairs can also be switched while it runs from the Serial Monitor (9600 baud) with commands such as "P3 ON", "P3 OFF", "ALL ON" and "ALL OFF".